The broadcast address will be setup automatically. Just start Xmapsy Essential and start MSFS2020. If you use XMapsy Essential, you need not to setup anything. The figure fs2ff settings shows extremely simple settings window. The latest release of fs2ff can be downloaded here. The program fs2ff does not require any complicated installation or setup, just download and run. This is likely due to a bug in the MS Flight Simulator software. The following two parameters in the text field of the settings dialog need to be set:Īt the time of writing (04Aug21), the MS Flight Simulator reports only traffic that has a tail number. FlightGear ¶įlightGear works well, even though position information is only broadcast when the simulated aircraft is moving. To end the connection to the flight simulator, simply leave the flight simulator’s Wi-Fi network. As soon as the flight simulator starts to broadcast information over the Wi-Fi network, the moving map of Enroute Flight Navigation will adjust accordingly. Once this is done, there is no further setup required.
#FLIGHTGEAR PLANE DOWNLOADS SOFTWARE#
Your flight simulation software needs to broadcast position and traffic information over the Wi-Fi network. Some routers have “security settings” that disallow data transfer between the devices in the “guest network” Set up your flight simulator ¶ Make sure that the router allows data transfer between the devices in the Wi-Fi network. Some routers deploy two networks, often called “main network” and a “guest network”. The computer that runs the flight simulator and the device that runs Enroute Flight Navigation are connected to the same Wi-Fi network. As long as the built-in satnav receiver is selected, all position information provided by your flight simulator is ignored. Open the “Settings” page in the main menu and tap on the entry “Primary position data source” and select the “Traffic data receiver” as the main source.
Make sure that the following conditions are met.
#FLIGHTGEAR PLANE DOWNLOADS MANUAL#
This manual assumes a typical home setup, where both the computer that runs the flight simulator and the device that runs Enroute Flight Navigation are connected to a Wi-Fi network deployed by a home router. To see the connection status, open the main menu and navigate to the “Information” menu. Enroute Flight Navigation treats flight simulators as traffic receivers.